Yardworks 060-3808-8, Owner'S Manual

GUIDELINES FOR USING EXTENSION CORDS

USE THE PROPER EXTENSION CORD. Make sure your extension cord is in good 

condition. When using an extension cord, be sure to use one of heavy enough gauge to carry 

the current your product will draw. An undersized cord will cause overheating. The table 

below shows the correct size to use depending on cord length and nameplate ampere rating. 

If in doubt, use the next heavier gauge.The smaller the gauge number, the heavier the cord.

Make sure your extension cord is properly wired and in good electrical condition. Always 

replace a damaged extension cord or have it repaired by a qualified person before using it. 

Keep your extension cords away from sharp objects, excessive heat and damp or wet areas.

Use a separate electrical circuit for your tools. This circuit should not be less than #12 wire and 

should be protected with a 15 A time delayed fuse. Before connecting the motor to the power 

line, make sure the switch is in the OFF position and the electric current is rated the same as 

the current stamped on the motor nameplate. Running at a lower voltage will damage the 

motor.

Minimum Gauge for Extension Cords (AWG)

(when using 120 V only)

Amp Rating

Total Length of Cord in Feet (meters)

More Than              Not More Than              25' (7.6 m)            50' (15 m)           100' (30.4 m)          150' (45.7 m)

Not Recommended

0
6

10
12

6

10
12
16

18
18
16
14

16
16
16
12

16
14
14

14
12
12

ELECTRICAL

WARNING:

THIS EDGER IS FOR OUTDOOR USE ONLY. DO NOT EXPOSE TO RAIN OR USE IN 

DAMP LOCATIONS.

WARNING:

                           ALTHOUGH THIS TOOL IS DOUBLE INSULATED, THE EXTENSION 

CORD AND RECEPTACLE MUST STILL BE GROUNDED WHILE IN USE TO PROTECT 

THE OPERATOR FROM ELECTRICAL SHOCK.

10