CONNECTING THE POLES
(See Figure 3.)
Before using the edger, a one-time assembly is required. When removed from the box, the two
poles are connected by an electrical cord as shown below.
1. Remove packaging material from cord and discard.
3. Align the slot (1) on the power-head pole and the button (2) on the handle pole (Fig. B). Slide
the handle pole into power-head pole until you hear the button click.
4. Lower the collar (3) on the handle pole end to the threaded base (4) and rotate clockwise to
secure (See Figure C).
2. Align the slot (5) on the lower power-head pole and the opening on the edger (Fig. A).
Slide the lower power-head pole into the edger until you hear the button click.
NOTE:
Handle pole and powerhead pole should not be able to separate from each other once
NOTE:
If it is difficult to assemble the lower power-head, please draw the cord tightenly in
position of Fig. B.
assembled correctly. Repeat above steps if poles can be separated.
Fig. 3
EDGER
HANDLE
POLE
COLLAR
CORD
POWERHEAD
POLE
(2) BUTTON
(3) COLLAR
(4) THREADED
BASE
(5) SLOT
(1) SLOT
ASSEMBLY
WARNING:
13
Failure to lock powerhead pole as directed above could result in serious injury or death.
Fig. A
Fig. B
Fig. C
Summary of Contents for 060-3808-8
Page 26: ...26 PARTS LIST...
