12
THE MIDDLE HANDLE AND THE UPPER HANDLE
a.
Attach the middle handle onto the lower handle.
Align the hole on middle handle with the hole on
lower handle at either side. Make sure the bracket
(a) on the middle handle is facing downwards as
shown in
Fig. 1.
(gear controller on the handle
should be on the right side facing the back of the
unit )
1
a
b.
Insert the handle locking lever with washer through
the aligned holes from the outside of the middle
handle. Attach the connector to the end of the
locking lever from the inner side of the lower
handle.
(See Fig. 2)
c.
Rotate the locking lever clockwise. Do not over
tighten.
(See Fig. 3)
3
d.
Close the locking lever to the middle handle to
lock the middle handle in place.
(See Fig. 4)
e.
Attach the upper handle onto the middle handle.
Choose an appropriate hole on the upper
handle as required. Insert the handle locking
lever with washer through the aligned holes
from the outside of the upper handle. Attach the
connector onto the end of the locking lever from
the inner side of the middle handle.
(See Fig. 5)
ASSEMBLY AND OPERATION
