16
The discharge chute can be adjusted 180 degrees
by rotating the chute rotation handle.
(See Fig. 16)
To adjust the height of snow discharge, hold and
squeeze the discharge chute deflector handle, and
then move the handle upwards or downwards. The
discharge chute deflector will be raised or lowered
afterwards. Choose one as required, release the
chute deflector handle to engage into the required
position and lock the chute deflector in place.
(See Fig. 16)
NOTICE:
This snow blower will only run with both
(2) batteries installed. ONLY use 2 of the same
batteries (Yardworks 20V 4.0ah batteries ) It is
recommended to charge the 2 batteries at the same
time.
To install:
1
,
Open the battery pack cover, slide the 2 battery
packs into the port inside of the compartment.
Push to the end with a sufficient force until the
battery packs click to lock in place.
(See Fig. 17)
2.Close the battery pack cover.
NOTICE:
The battery can only be installed in one
way.
To remove:
1.Open the battery pack cover.
2.Depress the battery pack release button at top
and hold, then pull the 2 battery packs one
by one out from the battery compartment.
(See Fig. 18)
ADJUSTING THE SNOW DISCHARGE HEIGHT
INSTALLING OR REMOVING THE BATTERY PACK
17
16
18
