Yardworks 60-2273-4, Owner'S Manual

To Remove the battery

1. Press in and hold the latch buttons       on both sides

    of the battery pack. 

(1)

2. Grasp the trigger handle 

(2)

firmly. Pull the battery pack out of the handle.

NOTE:

The battery pack fits snugly into the handle to prevent accidental dislodging. It may require a strong pull to 

To Install

1. Align the tongue 

(3)

of the battery pack with the cavity in the handle housing.

2. Grasp the trigger handle 

(2)

firmly.

3. Push the battery pack into the handle until both sides lock. The latch buttons will click when they lock.

4. Do not use force when inserting the battery pack. It should slide into place and click.

10

WARNING

2

Fig. C

ASSEMBLY INSTRUCTIONS

Battery pack (Fig. 

C

)

To avoid injury and to reduce the risk of electric shock or fire:
• Replace the battery pack or charger immediately if the battery case or charger cord is damaged.
• Always make sure the grass trimmer switch is OFF before inserting or removing the battery pack.
• Always make sure the battery pack is removed and the switch turned OFF before replacing spools or adjusting the line.
• Read, understand, and follow the Battery Charger instructions.

1

3

remove.

IMPORTANT!

 The battery is not shipped fully charged.

It is recommended that the battery be fully charged before the 

initial use.

With regular use, the battery pack will take 90 MINUTES or  less to charge fully. It is recommended that the battery be charged 

every 3 months when the trimmer is not in use. The battery's run time will improve after the third or fourth charge.