Picture 4.2 – Cylinder head with manifolds
1 – spring cap 236-1007024-V; 2 – cap liner 236-1007026-
Б; 3 – eduction valve 236-
1007015-
В4; 4 – valve cotter 236-1007028-А; 5 – induction valve
236-1007010-V; 6 – assembled collar of the induction valve 236-1007262; 7 – assembled
cylinder hear 238-1003013-D3; 8 – seat of the induction valve 236-1003108-
Б; 9 – seat of
the eduction valve 236-1003110-
В4
4.2.5 Quality of the valves and seats grinding should be checked for sealing pouring
the diesel fuel oil alternatively in the eduction and induction passages of the head with
installed and fastened valves and holding during 1 min. Leakage of the diesel fuel oil through
the valve joints with the seats is not permitted.
4.2.6 Before the installation in the guide bushings valve rods 3 and 5 should be
lubricated with the oil used in the engine lubrication system.
Summary of Contents for ???-236
