1-7
183574-1CD
183574-1CD
1
Introduction
1.3 System Layout
ArcWorld 50/50S/52/52S
1.3.3 Optional Equipment
The following optional equipment is available for the ArcWorld:
Stationary Tables: (AW50 and AW52 Only)
This table provides a place to position parts.
Torch Cleaner
This stand-alone device uses a pneumatic motor with a reamer to clean
the torch nozzle.
Wire Cutter
Automatically cuts welding wire to a desired length. A programmed path
brings the welding wire into the cutter jaw. Using a Robot output signal,
the pneumatic device will shear off the wire, leaving a clean edge at the
programmed stick-out length. A specific length of wire is used for touch
sensing on the Robot system.
Water-cooled Torch (with water circulator)
Reduces torch temperature and prevents the system from overheating.
TouchSense™
The Touch Sensing function enables the Robot to find the welding joint.
ComArc™
Seam tracking functions by weaving the welding wire in the joint and
sensing the current at each stroke of the weaving motion. If the detected
current at each stroke is not the same, the Robot will correct its path in a
direction required to make the current the same.
Digital Gas Flow Gauge
Provides a readout and diagnostic for the shielding gas to confirm if flow is
present. This sends a digital signal to the Controller to trigger an alarm
when detecting a low flow.
Beacon Light
Visual indicator of cell status and audible alert if an alarm occurs. Colors
indicate status conditions. Fence or post mounting is available for most
cells and typically is located in the front of the cell, near the operator
stations.
Tip Change Request (Buttons only, no box)
This is a standalone “Operator Station” with the buttons and indicators to
complement the tip change process. This is available for compact cells
where the Robot can move towards access or station door to allow the
operator to access the torch to do the tip change.
Enabling Device for Second Cell Occupant
Enabling device with holster allows additional personnel to enter the
workcell.
Wire Spool Mount
A bracket and cover to support cabling and mounting of a 30 lb spool to
the Robot. Also provided is conduit between the spool and wirefeeder.
Wire Delivery Kit for Bulk Wire
This kit includes brackets and conduit to attach to a customer provided
bulk spool.
34 of 126
