EN20
YASKAWA Electric
TOEP C710606 27 AC Drive - J1000 Quick Start Guide
5 Start Up
5
Start Up
Drive Setup Procedure
The illustration below shows the basic setup procedure. Each step is explained more detailed
on the following pages.
Select Normal / Heavy Duty
Set/check the basic parameters:
Connect the load, run the motor and check the operation
Fine tune and set application parameters if necessary.
Final check the operation and verify the settings.
Drive is ready to run the application
Intstall and wire the drive as explained.
Turn the power on.
Initialize the drive if necessary using parameter A1-01.
START
* b1-01, b1-02 for frequency reference and RUN command source
* H1-
, H2-
, H3-
, H4-
, to configure the I/Os
* Frequency reference values
* C1-
, C2-
for Acceleration/Deceleration times and S-curves
* E1-
, E2-
V/f pattern and motor data
Run the motor without load, check the operation and verify, if the
upper controller (e.g. PLC,...) commands to the drive work as
desired.
