YASKAWA CIMR-RB Series Instruction Manual Download

Page: 128 / 209

128

YASKAWA ELECTRIC

TOEP C710656 10B YASKAWA Power Regenerative Unit - R1000 Instruction Manual

7.2 Regenerative Unit Options and Peripheral Devices

Table 7.1

lists the names of the various peripheral devices, accessories, and options available for Yaskawa regenerative

units. Contact Yaskawa or your Yaskawa agent to order these peripheral devices.

• Peripheral Device Selection: Refer to the Yaskawa catalog for selection and part numbers.
• Peripheral Device Installation: Refer to the corresponding option manual for installation instructions.

Table 7.1 Available Peripheral Devices

Option

Model Number

Description

Power Options

24 V Power Supply

PS-A10LB (200 V class)
PS-A10HB (400 V class)

Provides power supply for the control circuit and option boards.

Note:

Parameter settings cannot be changed when the drive is operating

solely from this power supply.

Interface Options

USB Copy Unit (RJ-45/
USB compatible plug)

JVOP-181

• Can copy parameter settings easily and quickly to be later transferred to

another regenerative unit.

• Adapter for connecting regenerative unit to the USB port of a PC.

PC Cable

Commercially available
USB2.0 A/B cable.

Connect regenerative unit and PC when using DriveWizard Plus.
The cable length must be 3 m or less.

LCD Operator

JVOP-180

For easier operation when using the optional LCD operator. Allows for
remote operation. Includes a Copy function for saving the settings of
regenerative units.

LCD Operator Extension Cable

WV001: 1 m
WV003: 3 m

Cable for connecting the LCD operator.

Mechanical Options

Attachment for External Heatsink

–

Attachment for External Heatsink

Communications Option Cards

MECHATROLINK-II Interface

SI-T3

Used for running or stopping the regenerative unit, setting or referencing
parameters, and monitoring input current, output voltage, or similar items
through MECHATROLINK-II communication with the host controller.

CC-Link Interface

SI-C3
Available soon.

Used for running or stopping the regenerative unit, setting or referencing
parameters, and monitoring input current, output voltage, or similar items
through CC-Link communication with the host controller.

DeviceNet Interface

SI-N3
Available soon.

Used for running or stopping the regenerative unit, setting or referencing
parameters, and monitoring input current, output voltage, or similar items
through DeviceNet communication with the host controller.

PROFIBUS-DP Interface

SI-P3
Available soon.

Used for running or stopping the regenerative unit, setting or referencing
parameters, and monitoring input current, output voltage, or similar items
through PROFIBUS-DP communication with the host controller.

CANopen Interface

SI-S3
Available soon.

Used for running or stopping the regenerative unit, setting or referencing
parameters, and monitoring input current, output voltage, or similar items
through CANopen communication with the host controller.

Monitor Option Cards

Analog Monitor

AO-A3

Outputs analog signal for monitoring the output state (input frequency,
output voltage etc.) of the regenerative unit.
Output resolution: 11 bit signed (1/2048)
Output voltage: 0 to 10 Vdc (non-isolated)
Terminals: 2 analog outputs

Digital Output

DO-A3

Outputs isolated type digital signal for monitoring the run state of the
regenerative unit (alarm signal, during run, etc.)
Terminals: 6 photocoupler outputs (48 V, 50 mA or less)
2 relay contact outputs (250 Vac, 1 A or less 30 Vdc, 1 A or less)

TOEP_C710656_10B_1_0.book 128 ページ２０１５年１月８日　木曜日　午後８時５５分