3 Startup Procedure and Test Run
140
YASKAWA ELECTRIC
SIEP C710617 19A YASKAWA AC Drive CR700 Technical Manual
Note:
The keypad display differs depending on settings and conditions.
A -
A1-02 [Control Method Selection]
settings
B -
o2-04 [Drive Model (KVA)
Selection]
settings (2 or 3 digits)
C - Parameter backup data is not
registered
D - Backup data does not contain the
date Information
E - Backup date
■
Verify Keypad Parameters and Drive Parameters
This procedure verifies that the parameter setting values that were backed up in the keypad agree with the
parameter setting values in the drive.
Note:
•
Always stop the drive before you start to verify the parameters.
•
The drive does not accept Run commands while verifying parameters.
1.
Push
(Home) to show the HOME screen.
Note:
• The keypad will show [Home] in the top right corner when the HOME screen is active.
• If [Home] is not on
, push
(Back) to show [Home] on
.
2.
Push
(Menu).
3.
Push
or
to select [Parameter Backup/Restore], then push
.
4.
Push
or
to select the item to verify, then push
.
