YASKAWA ELECTRIC
SIEP C710617 19A YASKAWA AC Drive CR700 Technical Manual
659
45: Add Offset Frequency 2 (d7-02)
Setting
Function
Description
45
Add Offset
Frequency 2 (d7-02)
Sets the function to add the offset frequency set in
d7-02 [Offset Frequency 2]
to the frequency
reference when the terminal activates.
Note:
Refer to
“
d7: Offset Frequency
”
for more information.
46: Add Offset Frequency 3 (d7-03)
Setting
Function
Description
46
Add Offset
Frequency 3 (d7-03)
Sets the function to add the offset frequency set in
d7-03 [Offset Frequency 3]
to the frequency
reference when the terminal activates.
Note:
Refer to
“
d7: Offset Frequency
”
for more information.
47: Node Setup (CANopen)
Setting
Function
Description
47
Node Setup
(CANopen)
Sets the function in CANopen communications to start the Node Setup function to set the drive
node address from the host controller.
60: DC Injection Braking Command
Setting
Function
Description
60
DC Injection Braking
Command
When the DC Injection Braking command is input while the drive is in stopping operation, DC
Injection Braking is applied to stop the motor.
67: Communications Test Mode
Setting
Function
Description
67
Communications Test
Mode
Set the function for the drive to self-test RS-485 serial communications operation.
The Self-Diagnostics function connects the transmission terminal of the control terminal block to the reception
terminal. The function transmits the data that the drive sent to make sure that the drive can communicate correctly.
Note:
Refer to MEMOBUS/Modbus communications
“
Self-Diagnostics
”
for the self-diagnostics procedure.
72: Zero Servo
Setting
Function
Description
72
Zero Servo
Sets the function to hold a stopped motor.
This function will hold a stopped motor if an external force is applied or an analog reference is offset.
Note:
•
Refer to
“
b9: Zero Servo
”
for more information.
•
When you use the Zero Servo function, keep the Run command ON. Zero servo stops the motor and if you turn OFF the Run
command, it will not have power.
100 to 1FF: Inverse Input of 0 to FF
Setting
Function
Description
100 to 1FF
Inverse Input of 0 to
FF
Performs inverse input on the function of the selected MFDI. Sets the function for which to
generate inverse input by specifying the last 2 digits of 1xx (00 to FF).
To inverse the input of
E [ASR Integral Reset]
, for example, set
H1-xx = 10E [MFDI Function Select = ASR
Integral Reset (N.C.)]
.
Note:
Some functions can be for inverse input, and some cannot. Refer to Table 11.26 for details.
V/f
CL-V/f
OLV
CLV
AOLV
V/f
CL-V/f
OLV
CLV
AOLV
V/f
CL-V/f
OLV
CLV
AOLV
V/f
CL-V/f
OLV
CLV
AOLV
V/f
CL-V/f
OLV
CLV
AOLV
V/f
CL-V/f
OLV
CLV
AOLV
