9.2 Monitoring SERVOPACK Status
9.2.3 I/O Signal Monitor
9-6
9.2.3
I/O Signal Monitor
Use the following procedure to check I/O signals.
1.
Click the
Servo Drive Button in the workspace of the Main Window of the Sig-
maWin+.
2.
Select
Wiring Check
in the Menu Dialog Box.
The Wiring Check Dialog Box will be displayed.
3.
Click the
Monitor Mode
Button.
You can also use the above window to check wiring.
•
Checking Input Signal Wiring
Change the signal status at the host controller. If the input signal status on the window
changes accordingly, then the wiring is correct.
•
Checking Output Signal Wiring
Click the
Force Output Mode
Button. This will force the output signal status to change. If
the signal status at the host controller changes accordingly, then the wiring is correct.
You cannot use the
Force Output Mode
Button while the servo is ON.
Input signal status
Output signal status
Information
