YASKAWA GPD 315/V7 Instruction Sheet Download

Page: 8 / 8

Serial Communication Option Kit

for GPD 315/V7

Yaskawa Electric America Inc-www.drives.com

02Y00025-0514 Page 8 of 8

Date: 08/23/01

14) Install Digital Operator as shown in
Figure 14.

Figure 14

15) Reinstall faceplate and associated
screw.

Figure 15

Physical installation of the kit is now complete. For electrical and software set-up, consult the
manual accompanying this kit as well as the

GPD315/V7 Technical Manual

that accompanies

the drive.

Summary of Contents for GPD 315/V7

Page 3: ...01 4 Remove the digital operator from the top portion of the drive assembly Drive should now appear as shown in Figure 4 Figure 4 5 Use a diagonal side cutters to cut the three plastic tabs Figure 5 w black lines pointing to them that secure the protective cover over the GPD315 V7 s CN2 port Remove this protective cover Figure 5 ...

Page 4: ...8 23 01 6 The CN2 port should be exposed highlighted by black arrow Figure 6 after performing this operation Figure 6 7 The backside of the Serial Communication Option Kit is shown in Figure 7 Make sure that the blue ground wire on the back side of unit is looped through the case cut out highlighted by grey circle Figure 7 ...

Page 7: ... 01 12 Snap Serial Communication Kit securely in place as shown in Figure 12 Figure 12 13 Remove Decorative M3X8 5 Screw from plastic bag silver colored and place in recessed circular hole at top of Serial Communication Kit where screwdriver is presently located in Figure 13 Tighten this screw with Philips screwdriver Figure 13 ...

Page 8: ...ate 08 23 01 14 Install Digital Operator as shown in Figure 14 Figure 14 15 Reinstall faceplate and associated screw Figure 15 Physical installation of the kit is now complete For electrical and software set up consult the manual accompanying this kit as well as the GPD315 V7 Technical Manual that accompanies the drive ...