54
YASKAWA
TOEPC71061732E HV600 Drive Installation & Primary Operation
10
Drive Start-Up Procedure
1. Install and wire the drive.
2. Energize the drive.
3. Use
A1-06 [Application Preset]
to initialize the drive for a special application if necessary.
4. Set these functions:
•
Control method selection
•
Motor data
•
Frequency reference
•
Run command source
•
Acceleration and deceleration times
5. Run the motor without a load.
6. Make sure that the drive is operating correctly and make sure that the host controller is sending commands to the
drive.
7. Connect the load.
8. Run the motor.
9. Make sure that the drive is operating correctly.
10. Fine-tune and set application parameters, such as PID.
11. Do a final operation check and make sure that parameter settings are correct.
The drive is prepared to run the operation.
◆
Change Parameter Settings
This example shows how to change the setting value for
C1-01 [Acceleration Time 1]
. Do the steps in this procedure
to set parameters for the application.
1.
Push
(Home) to show the HOME screen.
Note:
• When the drive is in HOME Mode, the screen shows [Home] in the upper right-hand corner of the screen.
• If [Home] is not shown above the
, push
(Back).
2.
Push
(Menu).
3.
Push
or
to select [Parameters], then push
.
