YASKAWA
TOEPC71061732E HV600 Drive Installation & Primary Operation
55
4.
Push
or
to select [C Tuning], then push
.
5.
Push
or
to select [C1 Accel & Decel Time], then push
.
6.
Push
or
to select
C1-01
, then push
.
7.
Push
or
to select the specified digit, then push
or
to select the correct number.
• Push
[Default] to set the parameters to factory defaults.
• Push
[Min/Max] to show the minimum value or the maximum value on the display.
8.
Push
to keep the changes.
9.
Continue to change parameters, then push
[Back],
[Home] to go back to the home screen after
you change all the applicable parameters.
◆
Disable the Initial Setup Screen
Do the steps in this procedure to not show the initial start-up screen when the drive is energized.
1.
Push
(Home) to show the HOME screen.
Note:
• When the drive is in HOME Mode, the screen shows [Home] in the upper right-hand corner of the screen.
• If the screen does not show [Home] for
, push
(Back), and then push
to show [Home].
