5 Installation Procedure
24
YASKAWA
TOBP C730600 29C YASKAWA AC Drive-Option LCD Operator Installation Manual
◆
Connecting the LCD Operator Option to the Drive
This section contains instructions for connecting the LCD operator to V1000. For
instructions on connecting the LCD operator to the other drives, see the Technical Manual of
the drive connected to the LCD operator.
Plug the communication cable into the communication cable connector of the LCD Operator
Option and the drive communications port as shown in
Figure 11
. Ensure both cable ends
are firmly connected.
Refer to Item Names and Part Numbers (Sold Separately) on
page 12
for information regarding recommended cables.
Refer to
Table 1
for Built-in LED Display Behavior with a Connected LCD Operator
Option.
Note:
Use only Yaskawa recommended cables. Using a cable not specified may cause the LCD
Operator or drive to malfunction.
Note:
The STOP key on the drives built-in LED operator is the only functional key on the built-in LED
operator when the LCD Operator Option is connected to the drive and parameter b1-02 is set to
0 (LCD Operator Option). To disable the STOP key, set parameter o2-02 (STOP key Function
Selection) to 0 (Disable).
Figure 11
Figure 11 Communication Cable Connection
STOP
V1000
(Hz)
(Hz)
(A)
(V)
:
:
:
:
:
:
:
:
:
:
周波数指令
正転逆転選択
出力周波数
出力電流
出力電圧
モニタ
ベリファイ
セットアップ
パラメータ設定
オートチューニング
据え付け、運転の前には必ず取扱説明書を読むこと。
通電中および電源遮断後
5
分以内はフロントカバーを
外さないこと。
400V
級インバータの場合は、電源の中性点が接地
されていることを確認すること。（ 対応）
けが、感電のおそれがあります。
危 険
Read manual before installing.
Wait 5 minutes for capacitor discharge after
disconnecting power supply.
To conform to requirements, make sure
to ground the supply neutral for 400V class.
Risk of electric shock.
WARNING
MODEL:JVOP-180
ޓޓޓ
REV:A
PASSED
L/N :BY1-00004 PRG:0100
S / N : J007XE273710001
YASKAWA ELECTRIC CORPORATION
MADE IN JAPAN
Comm Port
LED
Operator
Communication Cable Connector
LCD Operator Option
Drive
