5 Installation Procedure
YASKAWA ELECTRIC
TOBP C730600 35B YASKAWA AC Drive Option LED Operator Installation Manual
21
■
Connecting the LED Operator to J1000
Note:
Attach the RS-232C Interface Option (SI-232/J) to the drive before connecting the LED
Operator Option to the drive.
Plug the communication cable into the communication cable connector of the LED Operator
Option and the communications port of the RS-232C Interface Option (SI-232/J) as shown
. Ensure both cable ends are firmly connected.
Numbers (Sold Separately) on page 10
for information regarding recommended cables.
NOTICE:
Use only Yaskawa recommended cables. Using a cable not specified may cause the LED
Operator or drive to malfunction.
Note:
The STOP key on the drives built-in LED operator is the only functional key on the built-in LED
operator when the LED Operator Option is connected to the drive and parameter b1-02 is set to 0
(LED Operator Option). To disable the STOP key, set parameter o2-02 (STOP key Function
Selection) to 0 (Disable).
Figure 11
Figure 11 Communication Cable Connection
STOP
J1000
S / N : J007XE273710001
Read manual before installing.
Wait 1 minute for capacitor discharge after
disconnecting power supply.
To conform to requirements, make sure
to ground the supply neutral for 400V class.
Risk of electric shock.
WARNING
1
2
3
4
5
:
:
:
:
:
:
:
:
:
6
7
8
9
据え付け、運転の前には必ず取扱説明書を読むこと。
通電中および電源遮断後
1
分以内はフロントカバーを
外さないこと。
400V
級インバータの場合は、電源の中性点が接地
されていることを確認すること。
（ 対応）
けが、感電のおそれがあります。
危 険
周波数指令
正転逆転選択
出力周波数
出力電流
出力電圧
モニタ
ベリファイ
セットアップ
パラメータ設定
Comm Port
LED Operator Option (JVOP-182)
LED
Operator
RS-232C
Interface
Option
Drive
Communication Cable Connector
