5
Disassembly and Reassembly of the Motor
5.2
Disassembly and Reassembly of the L-Axis Motor
5-6
HW1484673
HW1484673
5.2
Disassembly and Reassembly of the L-Axis Motor
5.2.1 YR-1-06VX50-A00
• Refer to
fig. 5-3(a) “Disassembly and Reassembly of the L-Axis
Disassembly
1. Turn OFF the power supply of the YRC1000.
2. Remove the encoder connector of the L-axis motor
(fixing bolt: pan-
head screw M2), and then disconnect the encoder cable.
3. Turn the connector on the cable side of the power connector for the L-
axis motor
, and then disconnect the power cable. If the connector
does not turn, remove the connector by holding the connector on the
cable side with a pair of plastic pliers etc.
4. Before removing the L-axis motor, support the L-arm with the chain
block, etc. to prevent the L-arm from rotating.
5. Unscrew the hexagon socket head cap screws
, and then remove
the L-axis motor
from the motor base
by using the tapped holes
on the L-axis motor
flange face. Be careful not to damage the oil
seal in the S-head at this time.
6. Unscrew the hexagon socket head cap screw
, and then remove the
pipe
, gear
, shaft
, key
, and shaft
.
Reassembly
1. Apply ThreeBond 1206C to the contact surface of the L-axis motor
and the shaft
, and then mount the shaft
and key
on the L-axis
motor
. (The key
is provided with the L-axis motor.) For the place
to apply sealing bond, refer to
fig. 5-3(b) “Surface to Apply Sealing
.
2. Pass the hexagon socket head cap screw
through the conical
spring washer and washer, and then apply LOCTITE 243 to the thread
part of the screw. Mount the shaft
, gear
, and pipe
on the
motor, and then tighten the hexagon socket head cap screw
with
the tightening torque shown in
table 5-2 “L-Axis Motor Parts Checklist”
.
3. Apply MP-1 grease to the lip part of the oil seal
.
4. Apply ThreeBond 1206C to the contact surface of the L-axis motor
flange surface and the motor base
, and then mount the L-axis
motor
on the motor base
while being careful not to damage the
oil seal
. For the place to apply sealing bond, refer to
5. Apply ThreeBond 1206C to the thread part of the hexagon socket
head cap screws
, and then tighten them with the tightening torque
shown in
.
6. Connect the encoder cable to the L-axis motor
, and then tighten the
connector fixing bolt (pan-head screw M2) with a tightening torque of
0.2 N•m.
(The connector fixing bolt is provided with the connector.)
7. As shown in
fig. 5-3(d) “Motor Power Cable”
, insert the power
connector to the L-axis motor
by aligning the key position, and then
turn the coupling nut on the cable side until it makes a clicking sound.
Confirm that the arrow marks on the connector on the motor side and
the connector on the wiring harness side match.
8. Turn ON the power supply of the YRC1000.
1
1
2
1
9
1
8
6
7
3
4
5
1
3
3
4
1
4
8
5
7
6
8
10
9
1
9
10
2
1
1
38/109
