6
Disassembly and Reassembly of the Speed Reducer
6.2
Disassembly and Reassembly of the L-Axis Speed Reducer
6-4
HW1484673
HW1484673
6.2
Disassembly and Reassembly of the L-Axis Speed
Reducer
• Refer to
fig. 6-2(a) “Disassembly and Reassembly of the L-Axis
Disassembly
1. Turn OFF the power supply of the YRC1000.
2. Disconnect the internal wiring harness from the S-head.
(Refer to
.)
3. In order to prevent the L-arm from falling, the L-arm must be supported
by using a chain block, etc. before removing it.
4. Unscrew the hexagon socket head cap screws
and
, and then
remove the L-arm from the speed reducer
.
5. Remove the L-axis motor
, and then remove the input gears
,
,
and .
(Refer to
chapter 5.2 “Disassembly and Reassembly of the L-Axis
If the speed reducer
is removed without removing the L-axis motor,
an external force will be applied to the shaft of the motor, causing the
shaft to bend or causing damage to the motor.
6. Unscrew the hexagon socket head cap screws
, and then remove
the speed reducer
and O-ring
from the S-head.
Reassembly
1. Mount the O-ring
on the speed reducer
.
2. Apply ThreeBond 1206C to the contact surface of the speed reducer
and the S-head, and then mount the speed reducer
on the S-
head. For the place to apply sealing bond, refer to
to Apply Sealing Bond on the L-Axis Speed Reducer”
. At this time, be
careful so that the O-ring
does not come off.
3. Tighten the hexagon socket head cap screws
with the tightening
torque shown in
table 6-2 “L-Axis Speed Reducer Parts Checklist”
4. Reassemble and mount the L-axis motor.
(Refer to
chapter 5.2 “Disassembly and Reassembly of the L-Axis
(When replacing the speed reducer, replace the input gear, too.)
5. Apply ThreeBond 1206C to the contact surface of the speed reducer
and L-arm, and then mount the L-arm on the speed reducer
. For
the place to apply sealing bond, refer to
“Surface to Apply Sealing Bond on the L-Arm on the Other Side of the
L-Axis Speed Reducer”
.
6. Tighten the hexagon socket head cap screws
with the tightening
torque shown in
.
7. Tighten the hexagon socket head cap screws
with the tightening
torque shown in
.
8. Mount the internal wiring harness.
(Refer to
.)
3
4
1
6
7
8
9
1
2
1
5
5
1
1
1
5
2
1
4
3
59/109
