9.2 Notes on Maintenance Procedures
9-6
Fig. 23 Battery Pack Connection
1. Turn the NX100 main power supply OFF.
2. Remove the mounting screws for the battery pack on the support.
3. Remove the battery pack from the holder.
4. Connect the new battery pack to an unconnected connector.
5. Remove the old battery pack from the circuit board.
6. Mount the new battery pack to the battery holder.
7. Reinstall the plate.
Connect the new battery pack before removing the old one so that the encoder absolute
data does not disappear.
Do not pinch the cable when the plate is installed.
Connector
Battery pack before replacement
See the step 5.
New battery pack
Circuit board
See the step 4.
NOTE
NOTE