9.2 Notes on Maintenance Procedures
9-15
9.2.7
Grease Replenishment for T-axis Gear
Fig. 29 T-axis Gear Diagram
1. Remove the plug on the exhaust port.
2. Remove the hexagon socket head cap screw on the grease inlet and install the grease
zerk A-MT6X1.
3. Inject the grease into the gear grease inlet using a grease gun.
4. Reinstall the plug on the exhaust port. Apply Three Bond 1206C on the thread part of
the plug.
5. Remove the grease zerk on the gear grease inlet and reinstall the hexagon socket
head cap screw. Tighten the screw with a tightening torque of 5 N·m (0.51 kgf·m).
Apply Three Bond 1206C on the thread part of the screw.
Grease type: Harmonic grease SK-1A
Amount of grease: 5 cc
(10cc for the 1st supply)
The exhaust port is used for air flow. Do not inject excessive grease into the gear grease
inlet.
Exhaust port
Gear grease inlet
(Plug LP-M5)
(Hexagon socket head cap screw M6)
NOTE
