ix
180788-1CD
HW1484370
Explosion-Proof Indication Label and Warning
MPX2600
Fig. : Explosion-Proof Indication Label (ATEX)
II2G
II(2)G
Ex ib pxb B T4 Gb/Ex ib B T4 Gb
Maximum Leakage :
50 kPa
5 kPa
Minimum Over Pressure(input) :
Maximum Over Pressure(input) :
4 min
320 L/min
KVA
Minimum Purge Flow Time :
Maximum Power :
Minimum Dilution Flow Rate :
Year of Manufacture :
A
3Px200V (-15%,+10%)50/60Hz
Maximum Current :
Maximum Voltage :
Serial No:
Maximum Line Pressure :
0.65 MPa
0.35 MPa
Minimum Line Pressure :
WARNINGS:
Pressurized enclosure, do not open when energized.
Enclosure contains lithium battery.
Remove all dust from this enclosure before connecting
or restoring the electrical supply.
Do not open when an explosive atmosphere is present.
Refer to instructions in the manual before opening.
Ambient Temperature
0°C to +45°C
YASKAWA ELECTRIC CORPORATION
2-1 Kurosakishiroishi, Yahatanishi-ku
Kitakyushu 806-0004 Japan
Pressurization System
Protective Gas Temperature :
0°C to +40°C
Manipulator
Intrinsically Safe Circuitry
Battery Back Up Circuitry :
DC4.5V 37.9mA
[Ex ib Gb]
Painting Unit
Setting Pressure for Purging :
0.18 to 0.20 MPa
Setting Pressure for Operating :
0.01 to 0.02 MPa
｛
Lithium/Iron Disulfide Battery (ENERGIZER L91)}
Battery backup circuit is consisted of battery
unit, position detector
and encoder separation board. The circuit is intrinsically safe circuit
when the power supply of the Controller is shut down or air purging.
The painting Unit combined shall be grounded at 100 ohms or less.
Relay barrier, isolated barrier and encoder
separation board (inside the painting Unit) shall be installed in a non-hazardous area.
3Px220V (-15%,+10%)60Hz
KW
Maximum Capacity :
Do not make any changes of the equipments and wiring in the manipulator,
relay barrier,isolated barrier and encoder separation board (inside the painting unit)
and combination equipment of Internal pressure explosion-proof structure.
This is pressurized enclosure.
1.
5.
9.
6.
8.
2.
3.
4.
7.
Non-Intrinsic safety circuit
Allowable Voltage :
AC250V 50/60Hz,DC250V
Manipulator :
Painting Unit :
0°C to +40°C
Minimum Flow Rate of Protective Gas:
Routine Test :
Pass
B
CML 17ATEX1034X
2503
15 NL/min
8.7
3.0
9.9
YR-MPX2600-C00
15 NL/min
Note 1
NJ
DWG.No,
Notified Body Number
Certificate Number
The place of production
may be replaced with the
following address it is the
ATEX-approved one.
Note 1
YASKAWA Europe GmbH
Yaskawastr.1, D-85391
Allershausen Germany
9 of 116
