4.15 Method 1: Copy One Subtask Job and Create Another Job
4-28
4.15.3
Correcting Positional Dislocation
In the job after mirror shift, a position may be dislocated due to the installation error. In this
case, all steps should be corrected by the same shift amount. For this operation, the parallel
shift job conversion function is used.
Setting the Items for Conversion
Operation
Explanation
1
Select {JOB} under the main
menu.
2
Select {JOB}.
The JOB CONTENT window appears.
3
Select {UTILITY} under the
pull-down menu.
4
Select {PARALLEL SHIFT
JOB}.
The PARALLEL SHIFT JOB window appears.
5
Specify the conversion items. Specify the following items.
SOURCE JOB
Selects the job before conversion. The job which is shown in
the JOB CONTENT window is set initially. To change the job,
perform the following procedure.
Move the cursor to the job name and press [SELECT]. The
JOB LIST window appears. Select the desired job.
STEP SECTION (Start Step
End Step)
Specifies the step section of the source job. All the steps are
set initially. If there is no steps in the source job, “***” is dis-
played. To change the section, perform the following proce-
dure.
Move the cursor to the step section indication and press
[SELECT]. The input buffer line appears. Input the step number
and press [ENTER].
PARALLEL SHIFT JOB
SOURCE JOB
STEP SECTION
DESTINATION JOB
COORDINATES
BASE POINT
<SHIFT VALUE> R1:S
L
U
R
B
T
0
0
0
0
0
0
EDIT
DISPLAY
UTILITY
DATA
Short Cut
Main Menu
CANCEL
EXECUTE
92/210
