8.5 Interpolation (INTERPOLATE)
8-33
8
8.5 Interpolation (INTERPOLATE)
The INTERPOLATE command positions the axis according to the target position that changes in sync with the
high-speed scan. The positioning data is generated by a ladder program.
(1) Operating Procedure
(2) Holding and Aborting
The axis will decelerate to a stop if there is no change in the target position each high-speed scan.
The Command Pause bit (OB
090) and the Command Abort bit (OB
091) cannot be used.
No.
Execution Conditions
Confirmation Method
1
There are no alarms.
Both IL
02 and IL
04 are 0.
2
The Servo ON condition.
IB
001 is ON.
3
Motion command execution has been completed.
IW
08 is 0 and IB
090 is OFF.
Set the motion setting parameters.
• Target Position: OL
1C
• Acceleration/Deceleration Filter Type:
OW
03
• Speed Loop P/PI Switch: OW
01
• Speed Feed Forward: OW
30
• Speed feed forward can be applied.
• Generate the positioning data each high-speed scan from the
ladder logic program.
• The travel speed is calculated automatically.
• The Command Pause (OB
090) cannot be used.
• The Command Abort (OB
091) cannot be used.
• Change a motion command to stop interpolation execution.
Execute the interpolation (INTERPOLATE)
motion command.
• Set OW
08 to 4.
Positioning starts.
• IW
08 will be 4 during positioning.
Change the Target Position (OL
1C)
every high-speed scan.
Positioning Completed
• IB
0C1 will turn ON.
Execute NOP motion command.
• Set OW
08 to 0.
Position
Speed
%
Time (t
0
Positioning Completed Width
POSCOMP