1.3 Safety instructions
DANGER!
There is a warning symbol on the housing of the power supply. This indi-
cates that all safety instructions listed in this manual must be observed
before commissioning!
DANGER!
Failure to comply with the specification may affect the protective functions
of the system!
The power supply is constructed and produced for:
n
the DC 24V supply of components.
n
operation within the environmental conditions specified in the technical data
n
the installation on a 35mm mounting rail in a control cabinet, which provides protec-
tion against fire, environmental influences and mechanical impact
n
industrial applications
DANGER!
This device is not certified for applications in
–
in explosive environments (EX-zone)
The manual must be available to all personnel in the
n
project design department
n
installation department
n
commissioning
n
operation
CAUTION!
The following conditions must be met before using or commis-
sioning the components described in this manual:
–
Hardware modifications should only be carried out when the system
has been disconnected from power!
–
Installation and hardware modifications only by properly trained per-
sonnel.
–
The national rules and regulations of the respective country must be
satisfied (installation, safety, EMC ...)
National rules and regulations apply to the disposal of the unit!
Warning symbol on the
housing
Intended use
Documentation
Disposal
VIPA System MICRO
General
Safety instructions
HB400 | PS | M07-2BA00 | en | 20-02
7
