6 Operation with the Drive Connected
24
YASKAWA ELECTRIC
TOEP C710656 09D YASKAWA Power Regenerative Unit - R1000 Quick Start Guide
shows the relationship between the combination of conditions and the set value of H1-
.
Table 11 Combination of Conditions
I/O Setup
Note:
The default setting functions can be seen in the connection diagram on page
Multi-Function Digital Inputs (H1-
)
The function of each digital input can be assigned in the H1-
parameters.
Multi-Function Digital Outputs (H2-
)
The function of each digital output can be assigned in the H2-
parameters. The setting value of these parameters
consist of 3 digits, where the middle and right digit set the function and the left digit sets the output characteristics (0:
Output as selected; 1: Inverse output).
Multi-Function Analog Inputs (H3-
)
The function of each analog input can be assigned in the H3-
parameters.
Multi-Function Analog Outputs (H4-
)
Use the H4-
parameters to set up the output value of the analog monitor outputs and to adjust the output signal
levels.
Test Run Checklist
Review the checklist before performing a test run. Check each item that applies.
Setting Value
Input contact
Detection
Operation selection
N.O. contact
N.C. contact
Always detect
Detect only
during operation Stop Unit (fault)
Continue
operation
(minor fault)
24
<1> When using an input contact, set whether to detect a fault when the signal opens or closes. (N.O.: External fault when closed, N.C.: External
fault when open)
<2> When using detection of a fault, set whether to always detect faults or to detect them only during operation.
–
–
–
25
–
–
–
26
–
–
–
27
–
–
–
2C
–
–
–
2D
–
–
–
2E
–
–
–
2F
–
–
–
No.
Checklist
1
Thoroughly read the manual before performing a test run.
2
Check the wiring.
3
Set the correct power supply voltage.
4
Turn on the power supply to the regenerative unit and drive.
5
Correctly sequence the Run commands.
6
The
should light after giving a Run command.
7
To give Run command and DC bus voltage feedback reference from the digital operator, press
key to set to
LOCAL.
8
To give Run command and DC bus voltage feedback reference from the control circuit terminals, press the
to set
REMOTE. (The LO/RE indicator is lit off while REMOTE is set.)
RE
LO
RE
LO
D1000R1000_QSG_E_conditional.book 24 ページ ２０１８年２月２６日 月曜日 午後２時３８分
