7.2 Specifications and Ratings
7.2.5 Medium-Capacity Servomotors, with Cores: Specifications
7-10
*3.
Refer to the following figure for the relevant locations on the Servomotor. Refer to the dimensional drawings of
the individual Servomotors for more information on tolerances.
*4.
The given values are for when the Servomotor shaft is mounted horizontally and shock or vibration is applied in
the directions shown in the following figures.
The strength of the vibration that the Servomotor can withstand depends on the application. Check the vibration
acceleration rate.
B
A
A
A B
B
Runout at end of output shaft
Runout of output shaft surface
Perpendicularity between mounting surface and output shaft
Concentricity between output shaft and flange outer diameter
Runout at end of output shaft
Load side
Non-load side
dia.
: Diameter determined by motor model.
dia.
dia.
Side to side
Front to back
Vertical
Shock Applied to the Servomotor
Vibration Applied to the Servomotor
Vertical
