8
YASKAWA
SIEP C730600 88F MECHATROLINK-III Technical Manual
Drive
Model (s)
Software Version
GA500
CIPR-GA50xxxxx
≥1010
GA700
CIPR-GA70xxxxx
≥1010
GA800
CIPR-GA80xxxxx
≥9010
CR700
CIPR-CR70xxxxx
≥1012
CH700
CIPR-CH70xxxxx
≥1012
*1
Refer to
“
PRG
”
on the drive nameplate for the software version number.
*2
Before you install the option on a YASKAWA AC Drive GA500, GA700, GA800, CR700, or CH700, make sure that the option
software version is PRG: 6202 or later.
Note:
Refer to the option package labeling in the field designated
“
PRG
”
(four digit number)
”
or the option labeling in the field designated
“
C/
N
”
(S + four digit number)
”
to identify the option software version.
◆
Install the Option on a GA500 Drive
An option card mounting kit is necessary to install the option on a GA500 drive. The option card mounting kit
model is: JOHB-GA500. This kit is sold separately.
Refer to the option card mounting kit manual for more information about installation.
A - Option
B - Option card mounting kit
components (sold separately)
C - Drive front cover
Figure 2.1 Option Card Mounting Kit
3
Receiving
After receiving the option package:
•
Make sure that the option is not damaged and no parts are missing.
Contact your sales outlet if the option or other parts appear damaged. Contact your sales outlet if there is
damage to the option or other parts.
•
Confirm that the model number on the option nameplate and the model listed in the purchase order are the same.
Refer to
for more information.
•
Contact the distributor where the option was purchased or contact Yaskawa or a Yaskawa representative about
any problems with the option.
