xiv
Transportation Precautions
NOTICE
Do not install or store the product in any of the following locations.
•
Locations that are subject to direct sunlight
•
Locations that are subject to ambient temperatures that exceed product specifications
•
Locations that are subject to relative humidities that exceed product specifications
•
Locations that are subject to condensation as the result of extreme changes in temperature
•
Locations that are subject to corrosive or flammable gases
•
Locations that are near flammable materials
•
Locations that are subject to dust, salts, or iron powder
•
Locations that are subject to water, oil, or chemicals
•
Locations that are subject to vibration or shock that exceeds product specifications
•
Locations that are subject to radiation
If you store or install the product in any of the above locations, the product may fail or be damaged.
Although machined surfaces are covered with an anticorrosive coating, rust can develop due to
storage conditions or the length of storage. If you store the product for more than six months,
reapply an anticorrosive coating to machined surfaces, particularly the core.
Consult with your Yaskawa representative if you have stored products for an extended period of
time.
C
A
UTION
Transport the product in a way that is suitable to the mass of the product.
Do not hold onto the cables attached to the Moving Coil when you move a Linear Servomotor.
There is a risk of disconnection, damage, or injury.
Make sure that the eyebolts are securely attached to the Linear Servomotor with no looseness
before you use them to move the Linear Servomotor.
There is a risk of injury or damage.
Do not use the eyebolts on a SERVOPACK or Servomotor to move the machine.
There is a risk of damage or injury.
When you handle a SERVOPACK or Servomotor, be careful of sharp parts, such as the corners.
There is a risk of injury.
Do not hold onto the magnet protective cover when you move a Magnetic Way.
There is a risk of injury from the edges of the cover. There is also a risk of deforming the cover.
Do not place an excessive load on the product during transportation. (Follow all instructions on
the packages.)
There is a risk of injury or damage.
NOTICE
A SERVOPACK or Servomotor is a precision device. Do not drop it or subject it to strong shock.
There is a risk of failure or damage.
Do not subject connectors to shock.
There is a risk of faulty connections or damage.
If disinfectants or insecticides must be used to treat packing materials such as wooden frames,
plywood, or pallets, the packing materials must be treated before the product is packaged, and
methods other than fumigation must be used.
Example: Heat treatment, where materials are kiln-dried to a core temperature of 56
°
C for 30
minutes or more.
If the electronic products, which include stand-alone products and products installed in machines,
are packed with fumigated wooden materials, the electrical components may be greatly damaged
by the gases or fumes resulting from the fumigation process. In particular, disinfectants containing
halogen, which includes chlorine, fluorine, bromine, or iodine can contribute to the erosion of the
capacitors.
Do not overtighten the eyebolts on a SERVOPACK or Servomotor.
If you use a tool to overtighten the eyebolts, the tapped holes may be damaged.
