3.2 Settings for Triggers at Preset Positions
3.2.1 Setting Table Details
3-5
3
T
rigger
s
at Pr
e
s
et Po
s
ition
s
3.2
Settings for Triggers at Preset Positions
You can output triggers at preset positions with the S or with MEM_WR commands
based on the following setting table. There are two types of setting tables: one for high-speed
outputs from line drivers and one for normal outputs from photocouplers.
3.2.1
Setting Table Details
This section gives details on setting tables.
Output Position
Set the reference position for outputting a signal for the trigger at the preset position.
Output Function
Select the axis number, output terminals, signal logic, and passing direction to use for the
trigger at the preset position.
Name
Output
Position
Output
Function
Output
Time
Output
Distance
Output
Position
Compensation
Output Setting 1
Output Setting 2
Output Setting 3
:
Output Setting 32
Size
Setting Range
Setting Unit
Default Setting
When Enabled
Classification
4
-2,147,483,648 to
2,147,483,647
Reference
units
0
Immediately
Setup
Size
Setting Range
Setting Unit
Default Setting
When Enabled
Classification
4
00000000h to
000012A1h
–
00000000h
–
Setup
Digit
Name
Setting
Description
0
Axis No.
*1
0
Set the axis number.
For an SGD7S SERVOPACK, set the axis number to 0.
Continued on next page.
