9.8 Configuration PROFINET IO device
n
The modules, which may be configured here are listed in the hardware catalog.
n
For the deployment of the PROFINET IO devices from Yaskawa you have to include
the modules into the hardware catalog by means of the GSDML file from VIPA.
n
After the installation of the GSDML file the PROFINET IO devices from VIPA may be
found in the hardware catalog at
‘PROFINET IO
è
Additional field devices
è
I/O
è
VIPA ... ’
Now the project engineering of the PROFINET IO controller is finished. Please link up
now your IO devices with periphery to your IO controller.
1.
For the project engineering of PROFINET IO device you search the concerning
PROFINET IO device in the hardware catalog at
PROFINET-IO
and drag&drop it in
the subnet of your IO controller.
2.
Assign a name to the IO device. The configured name must match the name of the
device. Information about setting the device name can be found in the manual of
the IO device.
3.
Enter a valid IP address. The IP address is normally assigned automatically by the
hardware configurator. If this is not desired, you can assign the IP address man-
ually.
4.
Link up the modules of your IO device in the plugged sequence and add the
addresses that should be used by the modules.
5.
If needed, parametrize the modules.
6.
Save, compile and transfer your project.
Install GSDML
Configure IO devices
System 300S
+
Deployment Ethernet communication - PROFINET
Configuration PROFINET IO device
HB140 | CPU | 315-4PN23 | en | 18-02
130
