5.
Set in the register MPI the transfer parameters of your MPI net and type a valid
address
.
6.
Switch to the register
Local connection
.
7.
Set the COM port of the PC and the transfer rate 38400baud for the MPI program-
ming cable.
8.
Transfer your project via
‘PLC
è
Load to module’
via MPI to the CPU and save it
with
‘PLC
è
Copy RAM to ROM’
on a memory card if one is plugged.
1.
Connect your PC to the PROFIBUS jack of your CPU via a MPI programming cable.
2.
Load your project in the Siemens SIMATIC Manager.
3.
Choose in the menu
‘Options
è
Set PG/PC interface’
.
4.
Select in the according list the "PC Adapter (PROFIBUS)"; if appropriate you have
to add it first, then click at [Properties].
5.
Set in the register PROFIBUS the transfer parameters of your PROFIBUS net and
enter a valid
PROFIBUS address
. The
PROFIBUS address
must be assigned to the
DP master by a project before.
6.
Switch to the register
Local connection
.
7.
Set the COM port of the PC and the transfer rate 38400baud for the MPI program-
ming cable.
8.
Transfer your project via
‘PLC
è
Load to module’
via PROFIBUS to the CPU and
save it with
‘PLC
è
Copy RAM to ROM’
on a memory card if one is plugged.
Transfer via PROFIBUS is available by DP master, if projected as master
and assigned with a PROFIBUS address before.
Within selecting the slave mode you have additionally to select the option
"Test, commissioning, routing".
5.10.2
Transfer via Ethernet
For transfer via Ethernet the CPU has the following interface:
n
X5: Ethernet PG/OP channel
n
X8: PROFINET IO Controller
So that you may access the Ethernet PG/OP channel you have to assign IP address
parameters by means of the "initialization".
Chap. 5.6 ‘Hardware configuration -
Ethernet PG/OP channel’ page 42
1.
For the transfer, connect, if not already done, the appropriate Ethernet port to your
Ethernet.
2.
Open your project with the Siemens SIMATIC Manager.
3.
Set via
‘Options
è
Set PG/PC Interface’
the access path to "TCP/IP
®
Network
card .... ".
Proceeding transfer via
PROFIBUS interface
Initialization
Transfer
System 300S
+
Deployment CPU 315-4PN23
Project transfer > Transfer via Ethernet
HB140 | CPU | 315-4PN23 | en | 18-02
53
