12.5 Clear of Error Record
12-6
HW0480311
HW0480311
12.5
Clear of Error Record
To delete the number of welding source errors, perform the clear operation of the error record.
The following explain how to clear the error record.
Fig. 21 Error Record Clear Mode
(1) In the Diagnosis mode, press "L" button and "Record" button simultaneously to set
the welding source ready for clearing of error record ("Err CLr on" is displayed).
(2) Press "RECORD" button with "Err CLr on" displayed to clear the error record. To
cancel the operation for clearing the error record, press "L" button again.
12.6
End of Diagnosis Mode
To end the diagnosis mode, turn OFF the MOTOWELD-EH500 main power once, then start
up the welding source as normal without pressing any buttons.
• Welding cannot be performed in the Diagnosis mode. After diagnosing,
be sure to start up the welding source in the usual mode.
Gas
V
A
Wire m/min
Type
File No.1
File No.2
File No.3
Power
Warning
Search
L
R
Press the buttons simultaneously.
Record
Common PRM Select
PRM Select
PRM Set
Weld, Type
User File Select
Auto Adjustment
/Individual
Auto Adj.
V
A
Wire m/min
Type
CAUTION
93/129
