HTTPS://WWW.ELECTROPOLIS.ES
18
English
Inversion Table Assembly Instructions Yatek ECO
STEP 2:
In this step we are going to assemble the
backrest and the headrest of the table to
the support already assembled in step 1:
First make sure to grab the following parts
for this step:
•
Support assembled in step 1
•
Nº 5
–
Backrest support
•
Nº 13
–
Headrest
•
8 x Nº 15
–
Flat washer
•
4 x Nº 16
–
Hexagonal bolt
•
4 x Nº 18
–
Anti-release nut
•
2 x Nº 20
–
Large cross-flat head
screw
•
Nº 21
–
Safety ring
•
Nº 22
–
Pulling bolt
➢
First step:
Use 2x cross-flat head screws (20) to assemble the headrest (13) on the
backrest (5).
➢
Second step:
Use the 4 hexagonal bolts (16), the 8 flat washers (15), the 4 nuts (18) to
assemble the metal plate of the side backrest support (5) and the metal plates that have
the 2 x Z shape supports (12), as shown in the image.
Very important:
The backrest (12) should stay in the same position as it is shown in the picture
above, and not the other way around, as highlighted by the red circle of the image.
➢
Third step:
Leave the safety pin (21) and the pulling bolt placed (22) although it is not
necessary to place them since they will be used to place the height adjustment frame (6)
into the desired extent later.
