8
GB
O R I G I N A L I N S T R U C T I O N S
PROPERTIES OF THE TOOL
The soldering tool has been designed for the purpose of soldering metals with tin and lead binders for soft soldering. A correct,
reliable and safe functioning of the tool depends upon appropriate operation, and therefore:
Before work with the tool, read the complete instruction and keep it.
The supplier will not be held responsible for any damage and injuries which occur as a result of inappropriate applications of the
tool, failure to observe safety regulations and the recommendations specified in these instructions. Improper application of the tool
will also cause cancellation of any guarantee rights due to incompliance with the sales contract.
EQUIPMENT
The soldering tool is provided complete and has no additional accessories.
TECHNICAL DATA
Parameter
Unit of measurement
Value
Catalogue number
YT-8271
YT-8272
YT-8273
Power supply mains voltage
[V]
~230
Power supply mains frequency
[Hz]
50
Rated power
[W]
30
60
80
Heating time
[min]
3
2,5
2
Working temperature of the soldering tip
[
O
C]
350
430
450
Maximum temperature of the soldering tip
[
O
C]
400
500
520
Dimensions of the soldering tip
[mm]
Ø3,8 x 70
Ø6 x 78
Ø6,8 x 64
Durability of the soldering tip
[h]
> 60
Mass
[kg]
0,07
0,09
0,11
Electric insulation class
I
Protection rating
IP20
GENERAL SAFETY CONDITIONS
NOTE!
Get acquainted with all the instructions below. Failure to observe them may lead to an electric shock, fire or injuries. The
notion of electric tool used in the instructions applies to all the tools which are powered with electric current, both wire tools and
wireless ones.
OBSERVE THE FOLLOWING INSTRUCTIONS
Place of work
The place of work must be properly illuminated and clean.
Disorder and poor illumination may be a cause of accidents.
Do not
work with electric tools in explosive environments, or those which contain inflammable liquids, gases or vapours.
Elec-
tric tools generate sparks, which may cause a fire in case of contact with inflammable gases or vapours.
Do not allow children
and outsiders to the place of work.
A lack of concentration may result in a loss of control over the tool.
Electric safety
The plug of the power supply cable must fit the mains socket. Do not modify the plug. Do not use any adapters whatso-
ever in order to adapt the plug to the socket.
Unmodified plug which fits the socket reduces the risk of an electric shock.
Avoid
contact with grounded surfaces, such as pipes, heaters and refrigerators.
Grounding of the body increases the risk of an
electric shock.
Do not expose electric tools to precipitation or humidity.
Water and humidity which gets into the electric tool
increases the risk of an electric shock.
Do not overload the power supply cable. Do not use the power supply cable in order
to carry the tool or to connect and disconnect the plug from the mains socket. Avoid contact of the power supply cable
with heat, oils, sharp tools and moving elements.
Damage to the power supply cable increases the risk of an electric shock.
In case work is realised outside closed areas, it is necessary to use extension cords designed for applications outside
closed areas.
Using a correct extension cord permits to reduce the risk of an electric shock.
Personal safety
Commence work in good physical and psychological conditions. Pay attention to what you do. Do not work if you are
tired or under effects of medicines or alcohol.
Even a moment’s inattention during work may lead to serious injuries.
Always
use individual means of protection. Always wear goggles.
Using individual means of protection, such as dust-masks, protec-
tive shoes, helmets and hearing protections permits to reduce the risk of serious injuries.
Avoid accidental activation of the
