16
O
P
E
R
A
T
I
N
G
M
A
N
U
A
L
GB
Damage
Possible solution
The air blown out of the slots at the top of
the tool or around the trigger
Check whether the screws are not loosened. Check the condition of the sealing.
The tool does not start or works slowly
The compressor does not guarantee the appropriate air supply. Connect the device to a more effi cient compressor.
Insuffi cient lubrication. Check the condition of the sealing.
Frequent jamming of the tool.
Incorrect or damaged connecting elements. The dispenser is dirty and does not guarantee appropriate supply of connect-
ing elements.
Insuffi cient power
Make sure the hoses have the correct internal diameter which must correspond at least to the value specifi ed in the table.
Check the adjustment of pressure; it must be set to the maximum acceptable value. Make sure the tool has been properly
cleaned and lubricated. If the problem persists send the tool for repair.
Once the functioning has been concluded, the casing, ventilation slots, switches, additional handle and protections must be
cleansed with a stream of air (at a pressure not exceeding 0.3 MPa), with a brush or a cloth without any chemical substances or
cleaning liquids. Tools and handles must be cleansed with a clean cloth.
Worn tools are recyclable waste – it is prohibited to dispose of them throwing them away along with domestic waste, since the
tools contain substances that are harmful for people and the environment! We ask for your active assistance in economic manage-
ment of natural resources and protection of the natural environment by sending the tools to a worn tools disposal point. In order
to reduce the quantity of waste that is disposed if, it is necessary to recycle them.
