YATO YT-0925 Instructions Manual Download

Page: 12 / 80

O R I G I N A L I N S T R U C T I O N S

Before operation of the tool can be commenced, the whole manual must be read and kept.

ATTENTION!

Read all the instructions mentioned below. If they are not observed, there is a risk of electric shock,

re or injury. The notion of „pneumatic tool” that is used in

the instructions refers to all tools that are powered with a stream of compressed air at appropriate pressure.

OBSERVE THE FOLLOWING INSTRUCTIONS

The place of work must be well lit and kept clean. Disorder and weak light may be causes of accidents. Do not use pneumatic tools where there is a risk of explosion, in

an atmosphere that contains in

ammable liquids, gases, or fumes. Prevent access of children and unauthorized persons to the place of work. Loss of concentration may

cause loss of control of the tool.

Safety

The connector of the pneumatic tool must

t the socket of the air supply duct. Do not modify the connector or the power supply socket. All ducts, connectors and sockets must

be clean, undamaged, in good technical state and suitable to be used with pneumatic tools. Pneumatic tools are not insulated from contact with electric energy sources, and

therefore any contact with grounded surfaces must be avoided (pipes, heaters and refrigerators). Grounding of the body increases the risk of electric shock. Do not expose

pneumatic tools to atmospheric precipitation or humidity. Water and humidity inside the tool increases the risk of damage and injury. Do not overload the air supply duct. Do

not use the duct to carry, connect or disconnect the connector from the compressed air tank. Avoid contact of the power supply cord with heat sources, oils, sharp edges

or mobile elements. Do not power the pneumatic tool with oxygen, in

ammable or toxic gases. Use only

ltered and “lubricated” compressed air whose pressure may be

regulated. Make sure that the processed object is properly

xed and will not move during processing.

Personal safety

Work in good physical and psychological condition. Pay attention to what you are actually doing. Do not work if you are tired or under in

uence of medicines or alcohol.

Even a moment of distraction during work may lead to serious injuries. Use personal protection. Wear protective goggles. Using personal protections like anti-dust masks,

protective shoes, helmets or hearing protector reduces the risk of serious injuries. While operating a pneumatic tool, wear protective gloves in order to protect yourself

from mechanic injuries and thermal in

uence of the tool. Avoid starting the tool by chance. Make sure the switch is in the position „OFF”, before the tool is connected to the

compressed air tank. Keeping a

nger on the switch or connecting of the tool when the switch is in the position “ON” may cause serious injuries. Before the pneumatic tool

is connected, remove all the wrenches and other tools that were used for adjustments. A wrench that is left on mobile parts of the tool may cause serious injuries. Keep bal-

ance. During the whole period of work, keep an appropriate position. It will facilitate the operation of the pneumatic tool in the case of unpredictable situations during work.

Use protective clothes. Do not wear loose clothes or jewellery. Keep the hair, clothes and gloves away from the mobile parts of the tool. Loose clothes, jewellery or long hair

may get caught in the mobile parts of the tool. Use dust removing systems and dust containers if the tool is equipped with them. Connect it correctly. A dust removing system

diminishes the risk of serious injuries. The feeding duct is under pressure what may cause its dynamic movements and serious injuries.

Operating of a pneumatic tool

Do not use the tool in a manner that does not correspond to its purpose. Do not overload the pneumatic tool. Use a proper tool for a given job. Do not exceed the maximum

acceptable working pressure. A proper choice of tool for a given job will guarantee more ef

cient and safer operation. Before the tool is regulated, accessories changed or

the tool stored, the feeding duct must be disconnected. Thus the pneumatic tool is protected from casual switching it on. Store the tools away from children. Do not permit