YATO YT-73350, Manual

9

GB

O R I G I N A L   I N S T R U C T I O N S

be replaced with a new one which is free of defects if these components are damaged. If 

the plug has a ground contact, it must be connected to a power supply socket which is also 

equipped with a ground contact. 

Ozonation instructions

Warning! Do not stay indoors while the ozone generator is operating. During ozonation, leave 

the room and return only 30-40 minutes after the ozone generator has 

fi

 nished its operation. 

Do not use ozonation at high air temperature, above 40

o

C, in a heavily smoke-

fi

 lled room or 

with a high humidity. In such conditions, ozonation will not be e

ff

 ective. 

Avoid direct contact of hands and eyes with the ozone outlet. 

If you experience discomfort, begin to cough, have a sore throat, a headache, feel drowsy 

in contact with ozone, the ozone generator must then be switched o

ff

  immediately and you 

must move to a place with clean air, preferably to an open space, if possible. 

In case of water ozonation, the appliance should be placed above the surface of water to be 

ozonated. 

Do not drink water immediately after ozonation. Wait 20-30 minutes after ozonation, then 

fi

 lter and boil the water. After cooling, the water should be drinkable. 

Ioniser use instructions

Air ionisation changes the charge of particulates in the air from positive to negative. Ionisation 

does not purify the air, but only facilitates the removal of particulates from the air. Ionisation 

should be used with air ventilation and 

fi

 ltration to assist in air puri

fi

 cation.  

There must be a minimum of 1 metre distance between the appliance and other electrical 

appliances if a negative ion generator is used. 

There must be a minimum of 0.5 m distance between the appliance and electrical life support 

equipment, e.g. pacemakers or arti

fi

 cial organs. 

Negative ions may interfere with the operation of other electrical equipment. If such inter-

ference is detected, switch o

ff

  the appliances, increase the distance of the ioniser from the 

appliances and try again.    

APPLIANCE OPERATION

Preparing for operation

Unpack the appliance by removing all packaging components. Clean the external surfaces of the appliance according to the 

instructions contained in the “Appliance maintenance” section. Set the appliance according to the instructions. 

Plug the power cord plug into the socket on the front of the appliance. The socket and plug are made to 

fi

 t together so that it is 

possible to connect in only one correct way.

Check that the appliance switch is in the “o

ff

 ” position – O, and the timer knob is in the “OFF” position.

Plug the power cord plug into the socket. The power supply network must be equipped with a protective conductor. 

Switch the appliance on by moving the switch to the “on” position – I. 

Start ozone generation by moving the timer knob to the “ON” position so that the generator operates continuously, or to a position 

marked with a number. The numeric position indicates the number of minutes for which the appliance will generate ozone. 

After the set time has elapsed, the appliance will automatically stop ozone generation. It is possible to set the time for up to 90 

minutes.

The appliance can be switched o

ff

  at any time by moving the switch to the “o

ff

 ” position - O.