6
GB
O R I G I N A L I N S T R U C T I O N S
PRODUCT CHARACTERISTICS
The spotlight is designed to illuminate small open spaces: building façades, monuments, advertisements, etc. The light source
consists of white LEDs, which means low power consumption and low power loss due to heating of the spotlight. The spotlight
housing is made of metal. The light source is protected by tempered glass with a gasket embedded in the frame. The lamp is
mounted by means of a bracket which allows the luminaire to be set vertically at an appropriate angle.
SAFETY INSTRUCTIONS
A quali
fi
ed electrician is required to install the spotlight.
Before starting the installation, switch o
ff
the power supply to the mains to which the spotlight is to be connected! Failure to do so
may lead to electric shock, resulting in serious injury or even death.
The luminaire has a non-replaceable glass and in case of damage or breakage of the protective glass, the entire spotlight should
be replaced immediately. The luminaire must not be used without the protective glass or with damaged protective glass!
The electrical wiring system powering the lamp should be e
ffi
cient, periodically checked, with properly selected fuses and should
provide protection against electric shock through quick shutdown.
Never use a lamp with visible mechanical damage, damage to the power cable insulation, broken spotlight glass, or other visible
damage. Damaged power supply cable cannot be repaired and must be replaced in their entirety by a quali
fi
ed specialist. All
adjustment and mounting operations must be carried out with the lamp power supply disconnected.
Do not touch the spotlight housing, as it becomes hot during operation and may cause burns.
SPOTLIGHT OPERATION
Illuminating component installation and replacement
It is not possible to replace the illuminating component. In case of its damage the whole spotlight should be replaced with a new
one.
Connecting the power supply
A quali
fi
ed electrician is required to connect the lamp power supply.
Before starting the installation, switch o
ff
the power supply to the mains to which the lamp is to be connected! Failure to do so may
lead to electric shock, resulting in serious injury or even death.
It is recommended that the lamp power supply network be protected by a residual current device (RCD) with a tripping current of
no more than 30 mA.
Tripod assembly
Set all tripod legs to their full width (III). If the tripod pole is too low, loosen the locking screw (IV), move the pole up and lock it in
position by tightening the screw. The pole can be extended by loosening the knob at the top of the pole, pulling out the inner part
of the pole and locking it in position by tightening the knob (V). Attach the lamp bracket to the top of the pull-out part (VI). In the
case of double lamps, a cable distributor bracket and a vertical bar should be attached to the top of the pole (VII). Attach the lamp
brackets on the ends of the vertical bar (VIII).
MAINTENANCE
Warning!
Before starting maintenance, disconnect the lamp from the power supply.
Clean the luminaire and the glass with a soft, damp cloth. Do not use pressure washers, cleaning agents containing abrasive or
corrosive substances, solvents or alcohol for maintenance.
This symbol indicates that waste electrical and electronic equipment (including batteries and storage cells) cannot be disposed of with other types of waste. Waste equipment
should be collected and handed over separately to a collection point for recycling and recovery, in order to reduce the amount of waste and the use of natural resources. Un-
controlled release of hazardous components contained in electrical and electronic equipment may pose a risk to human health and have adverse e
ff
ects for the environment.
The household plays an important role in contributing to reuse and recovery, including recycling of waste equipment. For more information about the appropriate recycling
methods, contact your local authority or retailer.
