YATO YT-82451, Manual

9

GB

O P E R A T I N G   M A N U A L

the tool and the ventilating holes. If any damage is detected, it is prohibited to continue working!

Note! 

All activities related to replacement of the soldering tip, light bulb, etc. must be performed with the power supply of the tool 

o

ff

 , so before you proceed to execute them: 

Remove the plug of the cord of the tool from the socket!

Before using the tool, make sure the parameters of the mains comply with those indicated in the rating plate. 

Before soldering clean thoroughly the metal elements to be soldered, as well as the soldering tip of the tool. In case the soldering 

tip is burned, it must be replaced with a new one. 

USING THE TOOL

Soldering should be performed by an adult who is acquainted with the safety regulations for soldering. 

Note!

 The tool has not been designed for continuous operation! The maximum time of operation is 12 seconds, after which work 

must be interrupted for at least 48 seconds.

MAINTENANCE AND INSPECTIONS

NOTE! Before any adjustment, technical service or maintenance, the plug of the tool must be removed from the mains socket. 

Once work has been concluded check the technical conditions of the electric tool by means of visual inspection and evaluation 

of the body and handle, the electric cord with the plug, operation of the switch, clearance of the ventilating holes, sparking of the 

brushes, the level of noise emitted by the bearings and gears, start and smoothness of operation. Within the guarantee period, 

the user must not dismantle the electric tool or replace any subassemblies or components, since it will make the guarantee void. 

Any irregularities observed during inspection or operation of the tool indicate it must be repaired by a service centre. Once work 

has concluded, the body, ventilating holes, switches, additional handle and protections must be cleaned, for example with an air 

jet (whose pressure must not exceed 0.3 MPa), brush or a dry cloth, without any chemicals or cleaning liquids. The tool and the 

handles must be cleaned with a dry, clean cloth.