10
GB
O R I G I N A L I N S T R U C T I O N S
rating plate. The plug must
fi
t into the socket. It is forbidden to modify the plug or socket in
any manner to make them
fi
t. The device must be connected directly to a single supply net-
work socket. It is forbidden to use extension cords, adapters, or double sockets. The supply
network circuit must be equipped with a 16 A protection. Avoid contact between the power
cord and sharp edges and hot objects and surfaces. During operation, the power cord must
always be fully extended, and the position of the power cord must be set so that it does not
become an obstacle during operation. The power cord should not be placed in a manner
that would pose a risk of tripping. The supply socket should be located in a place where it is
always possible to remove the device power cord plug quickly. Always pull the power cord by
the plug housing when unplugging it, never by the cord. If the power cord or the plug is dam-
aged, immediately disconnect it from the supply network and contact an authorised service
centre of the manufacturer for replacement. Do not use the product with a damaged power
cord or plug. The power cord or plug cannot be repaired and must be replaced with a new
one that is free of defects if these components are damaged.
WARNING! The metal components of the tool can be hot during and immediately after use.
Do not touch them, as it may cause severe burns. Allow the device components to cool
down. Use gloves that protect against high temperatures if you need to move these com-
ponents before they cool down. Make sure that the
fl
oor near the place of use of the device
is not slippery. This will prevent slipping, which can cause serious injuries. Never block or
restrict the
fl
ow capacity of the air inlet openings. Never point the device at people or animals.
Do not check the blowing temperature by directing the air stream towards any part of the
body. Never use the device as a hair dryer. Do not use the device in the bathroom or near
water. Do not touch the nozzle or tip end, as this may cause burns. After use, allow the tool
to cool down before storing it. Do not accelerate the process of self-cooling of the device
components in any manner.
DEVICE OPERATION
Installation of accessories
CAUTION! Only install the accessories when the supply voltage is disconnected. Pull the tool power cord plug out of the power
socket!
Before assembly and disassembly of the device, make sure that all components have cooled down.
Before starting assembly, make sure that the soldering station power switch is in the o
ff
position – O.
Connect the soldering iron cable to the port at the front of the soldering station housing. The plug has such a shape that it can
be connected in one correct way only. Secure the connection by screwing a metal plug ring on the thread around the port in the
soldering station housing.
Place the soldering iron in the stand (II).
Connect the power cord to the port at the back of the housing. The plug has such a shape that it can be connected in one correct
way only.
Position the station at the workplace, e.g., on the table to ensure easy access to the controls and that any object does not cover
the display reading. Place the soldering iron stand near the station to ensure free access to the soldering iron and prevent the
soldering iron tip from unintentional coming into contact with any object during operation, storage on the stand, and movement of
the soldering iron during operation. Due to the high temperature of the tip, leave at least 10 cm of free space around the stand.
The stand should be placed on a heat-resistant surface.
Insert a sponge designed to clean the tip during operation into the stand cavity. The sponge should be damp but not wet during
the entire operation period. This will prevent the tip damage.
Only after setting up the station and the stand and performing a trial operation can the station be connected to the power supply.
