9
GB
O R I G I N A L I N S T R U C T I O N S
PRODUCT SPECIFICATION
The soldering station is an electrical device intended for soldering, binding through soldering of metal materials using zinc-lead
solders and lead-free for soft soldering. The temperature control allows for soldering of
fi
ne electrical and electronic elements
without risk of overheating. The correct, reliable, and safe operation of the device depends on its proper use, therefore:
Read the entire manual before the
fi
rst use of the device, and keep it for future reference.
The supplier shall not be liable for any damage resulting from failure to comply with the safety instructions and recommendations
speci
fi
ed in this instructions manual.
ACCESSORIES
The product accessories are shown in the
fi
gure (I).
TECHNICAL PARAMETERS
Parameter
Unit of measurement
Value
Catalogue No.
YT-82456
Rated voltage
[V~]
220 – 240
Rated frequency
[Hz]
50
Rated power
[W]
75
Soldering iron supply voltage
[V DC]
24
Temperature
[
O
C]
200 – 480
Temperature stability
[
O
C]
+/- 1
Insulation class
I
Net weight
[kg]
2.1
Tip-to-ground resistance
[
Ω
]
<2
Tip-to-ground voltage
[mV]
<2
USB port
5 V DC / 1 A
SAFETY INSTRUCTIONS
Irresponsible use of the equipment can cause
fi
re, therefore exercise caution when using the
equipment in areas where combustible materials are present; do not direct a stream of hot air
at the same spot or place the soldering iron tip to the same spot for an extended period; do
not use the equipment in an explosive atmosphere; be aware that heat may be transferred
to combustible materials out of sight; place the equipment on its stand after use and leave
it to cool down before storage; do not leave the equipment unattended when switched on.
Before starting work, make sure that the housing and the power cord and plug are not dam-
aged. In case of damage, do not proceed with work.
Children must not use this equipment. Children should not play with the equipment. Chil-
dren left unattended should not be allowed to perform the cleaning and maintenance of the
equipment. This equipment may not be used by persons with reduced physical or mental
abilities and persons with no experience or knowledge of the equipment, if not supervised or
instructed on its safe use so that the risks associated with it are understood.
The device is not designed to operate in high humidity conditions. The temperature at the
place of the device’s use must be within the range of 0
O
C ÷ +40
O
C, and the relative humidity
must be below 70% without condensation. Do not expose the device to precipitation.
Before connecting the device to the power supply, make sure that the voltage, frequency,
and performance of the supply network correspond to the values shown on the device’s
