19
GB
O R I G I N A L I N S T R U C T I O N S
Replacement of the engine oil
Remove the bolt fixing the side panel and remove the panel itself. (III)
Open the oil inlet and remove the oil level gauge.
Under the drain hole place a container, and inclining the generator drain the old oil.
Fill oil in accordance with the procedure indicated in „PREPARATIONS FOR OPERATION”.
Storage of the generator
Open the fuel inlet, drain the fuel from the tank, e.g. using an appropriate pump.
Close the fuel filter lid. Set the deaeration valve to „OFF”.
Fill the oil tank, in accordance with the aforementioned procedure.
Pull the starting cord so as the engine makes a few revolutions.
Stop pulling the cord when you feel resistance.
Clean the external elements of the generator.
The generator must be stored in a dry, well ventilated place under roof.
The generator must be stored in horizontal position.
Summary of Contents for YT-85421
