YAUFEY PD161D, User Manual

OPERATIONS

TIMER setting: Press and hold the Timer Button to change the delay timer 
at 1 hour increments up to 24 hours. After TIMER setting, the control will 
display the remaining time (8,7,6, etc.) until the unit either starts or stops. 
If  you press the TIMER button again, the control will display the room 
temperature like before. After that, pressing the TIMER button again at any 
time will stop the TIMER function. For the Delay Start, the fan speed and 
humidity will maintain the same as the previous setting. Adjusting the timer 
setting to 0.0 will cancel the Auto Start/Stop function.

NOTE:

Before entering TIMER setting, please make sure the dehumidifier has been 
connected to the power source.

Before entering TIMER setting, please press Setting Button to set a desired 
room humidity first.

When the dehumidifier is running at a lower temperature, the system will 
automatically determine if there is frost, and if frost is present, it will 
automatically defrost.

Defrost action: The fan runs at a high speed while the compressor stops, 
and the LCD screen display the defrosting symbol.

4.        Speed Button

Control the fan speed. Press this button to select either High or Normal fan 
speed. A higher fan speed will result in quicker moisture removal. Set the 
fan control to high for maximum moisture removal. When the humidity has 
been reduced and quiet operation is preferred, set the fan control to normal.

5.        “Tank Full” Indicator Light

When the water tank is full, the light will flash and the machine will 
automatically shut down. After the water in the water tank is emptied, 
please put the water tank back in place, then the indicator light will turn off, 
and the machine will restart.

6.        Auto Defrost Feature