SERVICE TIPS
BRAVO 21 ASSEMBLY, Page 2
STEP 4
Insert the throttle cable inside the left handle tube. The cable
will come out at the bottom of the tube. Install the throttle cable
to the engine per the illustration. Install the edge of the cable
sheath in line with the edge of the clamp as illustrated.
STEP 5
Verify that the throttle control is adjusted properly as follows:
- Move the throttle control to the Full Throttle position.
Place the throttle cable
below the screw
Place the throttle cable
sheath at the edge of
the clamp.
Place the throttle cable
in the upper hole
- In the full throttle position the two arms at the throttle
mechanism on the engine should touch as illustrated below.
Choke
Full Throttle
Idle Throttle
Engine Off
(BBC version)
OK
Following these steps for the throttle adjustment will ensure
that the Honda engine performs properly.
The engine speed is adjusted to 3100 RPM at the factory.
STEP 7
To assist with the installation of the drive cable to the lower
control bar push the control bar past the spring lock (1) that nor-
mally retains the control bar in a comfortable operating position.
Insert the end of the spring into the hole (2) in the control bar.
- Pull back on the cable adjustment knob and insert into the slot
of the control panel.
- Pull up on the control bar to check the function.
- Make the adjustment to the knob on the drive cable during
operation
1
2
STEP 6
Install the BBC (Blade Brake Clutch) cable to the hook on the
BBC mechanism on the control panel. Pull in the cable sheath
and insert it into the hole in the control panel.
It is important to understand the function of the BBC system
before operating the mower. Follow the instructions in the Op-
erator’s Manual.
