Link CX-24 User’s Manual
Version 1.0
Page ii
February 2004
MICROWAVE RADIO RADIATION WARNING
When installed properly, the Link CX-24 radio equipment complies with the limits for
human exposure to radio frequency (RF) fields adopted by the Federal Communications
Commission (FCC). All YDI Wireless microwave radio equipment is designed so that
under normal working conditions, microwave radiation directly from the radio is negligible
when compared with the permissible limit of continuous daily exposure recommended in
the United States by ANSI/IEEE C95.1-1991 (R1997), Safety Levels with Respect to
Human Exposure to Radio Frequency Electromagnetic Fields, 3 kHz to 300 GHz.
Microwave signal levels that give rise to hazardous radiation levels can exist within
transmitter power amplifiers, associated RF multiplexers, and antenna systems. Never
look into the front of an open RF connection or RF antenna as eyes are particularly
vulnerable to radiation. Do not disconnect RF coaxial connectors, open microwave units,
or break down any microwave screening while the radio equipment is operating.
FCC NOTICE
This device complies with part 15 of the FCC rules. Operation is subject to the following two
conditions:
1. This device may not cause harmful interference, and
2. This device must accept any interference received, including interference that may cause
undesired operation.
* Note: The manufacturer is not responsible for any radio or TV interference caused by
unauthorized modifications to this equipment. Such modifications could void the user's
authority to operate the equipment.
These products are labeled with one of the following FCC ID numbers:
FCC ID: NM5-CX-DS3-ETH-24
© 2004 YDI Wireless.
All Rights Reserved. No part or parts of this document may be reproduced,
translated, stored in any electronic retrieval system or transmitted, in any form or by any means,
electronic, mechanical, photocopied, recorded or otherwise, without the prior written permission of YDI
Wireless.
