Link CX-24 User’s Manual
Version 1.0
Page 31
February 2004
Figure 2.13 – Setting the Link CX-24 Polarization – Vertical Polarization Shown
29
Install the pole-mount bracket as described below
a) Fit the adaptor bracket (X) to the back of the Link CX-24 unit noting polarization requirements
as discussed above, by aligning the four mounting studs on the back of the unit with the adaptor
bracket holes and securing to the unit using four M5 nuts, flat washers, and lock washers, as
shown in Figure 2.14. Tighten hardware (four places). Torque to 5.7N-m (4.2 lb-ft). Note the
position of the serrated edge of bracket (X).
b) Attach the pole-mounting bracket (A) to adaptor bracket (X) by using one M8 x 40L bolt, flat
washers, lock washer, and nut, as shown in Fig 2.14. Do not tighten at this stage.
IMPORTANT: Ensure that the serrated edges on both brackets, (A) and (X), are facing each
other.
