www.ydlidar.com Copyright 2015-2019 EAI
2
/
12
WINDOWS USAGE GUIDE
Device connection
When evaluating and developing X2 under windows, you need to interconnect X2
and PC. The specific process is as follows:
FIG 1 YDLIDAR X2 CONNECTION STEP 1
FIG 2 YDLIDAR X2 CONNECTION STEP 2
First connect the adapter board and X2, then connect the USB cable to the USB port of
the adapter board and PC. Note that the Micro interface of the USB cable is connected
to the USB_DATA.After X2 is powered on, it is in idle mode without turning its motor.
The USB interface’s drive current in some development platforms or PCs is weak, so X2
needs a +5V auxiliary power supply to support its normal work.
