www.ydlidar.com Copyright 2015-2019 EAI
7
/
12
FIGURE 10 CLIENT SETTINGS BOX
As shown in the figure, you can configure and detect the Lidar on this setup page, as well
as Lidar firmware upgrade, client software upgrade, etc.
SAVE DATA
During Lidar scanning,click
，
Save the point cloud data as prompted.The system will
save the point cloud information scanned in a circle according to the following format.
FIGURE 11 POINT CLOUD DATA SAVE FORMAT
ANGLE CALIBRATION
During the mechanical assembly of the Lidar, the user may have a deviation in the zero
angle. In this case, the angle calibration function of the client can be used to calibrate
according to actual needs. The specific operations are as follows:
(1) Unlock calibration function
Click the unlock control
, the system will pop up the login box, the default password is
ydlidar. The effect of these controls
will change after unlocking.
(2) setting the baseline
Click
and the system will provide a baseline of the appropriate size as a reference for
the adjustment.
(3) Adjusting the angle
Click
to adjust the angle to the appropriate position.
(4) save configuration
