Administrator’s Guide for SIP-T2 Series/T19(P) E2/T4 Series/CP860 IP Phones
294
Parameters
Permitted Values
Default
Description:
Configures the delay time (in seconds) for the IP phone to automatically dial out the
entered digits without pressing a send key.
Note: It works only if the value of the parameter ―phone_setting.predial_autodial‖ is
set to 1 (Enabled).
Web User Interface:
Settings->Preference->Inter Digit Time(1~14s)
Phone User Interface:
None
To configure live dialpad via web user interface:
1.
Click on Settings->Preference.
2.
Select the desired value from the pull-down list of Live Dialpad.
3.
Enter the desired delay time in the Inter Digit Time(1~14s) field.
4.
Click Confirm to accept the change.
Call waiting allows IP phones to receive a new incoming call when there is already an
active call. The new incoming call is presented to the user visually on the LCD screen.
Call waiting tone allows the IP phone to play a short tone, to remind the user audibly of
a new incoming call during conversation. Call waiting tone works only if call waiting is
enabled. You can customize call waiting tone or select specialized tone sets (vary from
country to country) for your IP phone. For more information, refer to
on page
The call waiting on code and call waiting off code configured on IP phones are used to
activate/deactivate the server-side call waiting feature. They may vary on different
servers.
Summary of Contents for CD860
